Loading ...
Loading ...
Loading ...
78 GETTING TO KNOW YOUR VEHICLE
TO CLOSE THE HOOD
Hoods equipped with gas props are closed from
the point where the props no longer hold the hood
open.
TAILGATE
OPENING
The power tailgate may be opened by pushing the
tailgate release pad located on the tailgate door.
The tailgate damper strut will lower the tailgate to
the open position (if equipped).
Electronic Tailgate Release — If Equipped
The key fob may be equipped with an
electronic release feature for the
ta
ilgate, allowing hands-free tailgate
opening. To activate, push and release
the Tailgate Release button on the key fob twice
within five seconds. The tailgate door will unlatch,
and slowly lower into the open position.
If equipped, a button on the center overhead
console inside the vehicle can be used to release
the tailgate. An indicator light may also signal when
the tailgate is open.
For the tailgate to lower, the vehicle must be
stationary and in PARK or NEUTRAL.
NOTE:
The optional Tri-Fold Tonneau Cover Ú page 89
may prevent electronic tailgate release. The
T
on
neau Cover must be removed or folded up
before releasing the tailgate.
CLOSING
To close the tailgate, push it upward until both
sides are latched.
The tailgate can be locked using the key fob lock
button.
TAILGATE REMOVAL
NOTE:
Removing the tailgate will disable the rearview
ca
mera function.
To remove the tailgate, refer to the following
instructions:
1. Disconnect the wiring harness for the rear
camera and or power locks (if equipped)
Ú
page 79.
2. U
nlatch the tailgate and remove the support
c
ables by releasing the lock tang from the
pivot.
NOTE:
Make sure tailgate is supported when removing
su
pport cables.
Locking Tang
WARNING!
Be sure the hood is fully latched before driving
your vehicle. If the hood is not fully latched, it
could open when the vehicle is in motion and
block your vision. Failure to follow this warning
could result in serious injury or death.
CAUTION!
To prevent possible damage, do not slam the
hood to close it. Use a firm downward push at
the front center of the hood to ensure that both
latches engage.
Loading ...
Loading ...
Loading ...