Loading ...
Loading ...
Loading ...
t
HM66 ENbook Page 21 Thursday Februar,¢ 23. 2006 2:49 PM
To set the Quick Restart TM feature:
1Press MyNUand open tile Setup menu.
2HigMight Quick Restart and press •.
3Press • or • to select either On or Off and Press @.
Note: tf Quick Restart is set to Off and you turn off the TV, it
can take several seconds for the picture to appear when you
turn on the TVagain. See "important notice about hot lamp
restart," below.
tf Quick Restart is set to On and you turn off the TV,the
following will occur for a few minutes.
•Thescreen (lamp) lights dimly, and
• Thefans continue to run.
This is a function of the Quick Restart Shutdown mode and is
not a TVmalfunction, tf you do not prefer this, set the Quick
Restart feature to Off
When the Quick Restart feature is set to Off, if you repeatedly
turn the TVon and off in a short period of time, the useful
service life of the lamp may be shorter than the average useful
service life (_. page 47).
IMPORTANT NOTICE ABOUT "HOT LAMP RESTART"
When the TV has been powered on long enough for
the lamp unit to get hot, it may take severn minutes for
the picture to appear on-screen in the following
situations:
°When the Quick Restart TM feature is set to Off and
you turn the TV off and then on again within a few
minutes; or
•If the TV is on when a short-term power failure,
power surge, or other similar power failure occurs,
such that the TV loses and regains power within a
few minutes.
This is a property of DLP TM TV lamp technology
and is NOT a sign of malfunction.
If this occurs, the yellow LED on the TV front panel will
blink (and the blue LED will be lit solid) until the TV is
finished restarting the lamp and the normal picture
appears. If both LEDs are blinking, you will need to
turn the TV off and then on again to restart the lamp.
Viewingthe digitalsignalmeter
You can view tile digital signal meter in tile ANT 1 and ANT
2 digital TV input sources only.
To view the digital signal meter:
1
2
3
Press MffNUand open tile Setup menu.
Highlight Installation and press ,_.
A new set of Installation menu icons will appear on-
screen, as shown below.
Open the Terrestrial menu, highlight Signal Meter,
and press @.
Channel Program
4Press ••'_ • to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
iiiiiAnt.... 1 ii;i;i;
Physical Digital Channel 4
Virtual Digital Cha,meJ 4/1
To close the screen and return to the Terrestrial
menu:
Highlight Done and press @.
To return to normal viewing:
Press EXiT(._),
21
HM66 (E/F) Web 213:27(
Loading ...
Loading ...
Loading ...