Loading ...
Loading ...
Loading ...
Installation Instructions
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flmnes.
The air a(!iusnnent shutter fiw the top (broil) bm'ner is
in the center of the rear wall of the oxen.
adjustment
shuEer
The shutter fi)r fl_e bottom (oven) burner is near the back
wall behind the storage drawer or kick panel. Remove the
(hvm_r or panel. See the Careandcleaningoftherange section.
To adjust the flow of air to either burner, loosen the
Phillips head screw mad rotate the shutter toward open
or dosed position as needed.
The flames fiw the top (broil) bm'ner should be steady
with approximatel) 1" blue cones and should not extend
out oxer the edges of the burner baffle.
To detemfine if the bottom burner flames are burning
properly, relnove the oven bottom. Haines should have
approximately 1" blue cones and, if range )s supplied
with natural gas, should burn with no yellow tipping.
(_._]th most I,P gas, small yellow tips at the end of outer
cones are nomml.) Flames should not litt off burner
ports. If lifting is observed, gradually reduce air shutter
opening tmtil flames are stabilized.
[] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY (CONT.)
Oven bottom'_
To remove the oven bottom:
A. Remove the kmu'led screws holding down rear of the
oven bottoi/),
B. Grasp the oven bottom at finger slots on each side.
C. i,ifl the rear of the oven bottom enough to clear the
lip of the range fl'ame, push it back, and then pull it
tip a)ld otlt.
[] LEVELING THE RANGE
A, Install the oven shelves in tile oven and position the
range where it will be installed.
Raise
1_ range Lower
Lower range
.)_ range
Leg _ ,A.
leveler -"_'_
Raise4_'_ x'_
range_
(on some models) (on some models)
B. Check tot levelness by placing a spirit level or a cup,
partially filled with wate); on one ot the oven shelves.
If using a spirit level, take two readings--with the level
placed diagonally fi)_t in one direction and then
the othe):
C. ]-%m(we tile storage drawer or kick panel. See the Care
and cleaning of the range section. The tl"ont leveling legs
can be a(!iusted fl'om the bottom and the rear legs can
be a(!iusmd ti'om the top or the bottom.
D. Use an open-end or ac!iust;d)le wrench to a(!itlst the
leveling legs tmtil the range is level.
E. Mter the range is level, slide the range away ti'om the
wall so that the Anti-Tip device can be installed.
42
Loading ...
Loading ...
Loading ...