Loading ...
Loading ...
Loading ...
I Installation Instructions I Range
Iffyou have questions,call 1.800.GE.CARESor ,isit our _:ebsite at: www.GEAppliances.com
I
I
In the Commonwealth of Massachusetts:
• This product Inust be installed bv a licensed phunber
or gas fitter.
*When using ball-tyI)e gas shut-offvalves, they shall be
the T-handle type.
• A flexible gas connector; when used, must not exceed
3 tibet.
BEFORE YOU BEGIN
Read these haslructions completely mad caJcefully.
Installation of this rmage must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Cmaada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propmae Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified lay
CSA International according to ANSI Z21.1, latest
edition mad Canadima Gas Association according to
CAN/CGA-I.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should tollow.
You will find these precautions in the Important Safety
Information section in the front of this manual. ]lead
them careflfllv:
•IMPORTANT -S ,.ethe ei= t,.cti,m
fin" local electrical inspector's use.
•IMPORTANT - ,ll
codes and ordinances.
• Note to Installer -Be sure to leave these
instructions with the Consume_:
• Note to Consumer - Kee I) these instructions tot
flmue reference.
•Note -This appliance must be propedy grounded.
•Servicer - The electrical diagram is in an envelope
attached to the back of the range.
• Skill level - Installation of this appliance requi_es basic
mechanical skills.
• Proper installation is the responsibility of the installe_:
• Product tifilure due to improper installation is not
covered under the _.Varrant_:
PART INCLUDED
Anti-Tipbracketkit
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flmmnable vapors mad liquids ha the vichtity of this
or may other appfimace.
If you smell gas:
Open windo_vs.
@Don't touch electrical switches.
OExtinguish any open flame.
hnmediately call your gas supplie_:
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-bladescrewdriver Open-endor
adjustablewrench
Pencilandruler __
Level
Pipewrenches(2) ti_======="
(onefor backup) Drill, awl or nail
MATERIALS YOU MAY NEED
• Gas line shut-otfvalve.
• Pipe joint sealant or Ui,-ai)proved pipe thread tape
with Teflon':: that resists action of natural and I,P gases.
•Flexible metal appliance connector (l/2" I.D.)
A 5-toot length is recommended fi)r ease ot installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
•Flare tlilioil adapter fin" connection to gas supply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare union adapter for connection to i)ressure
regulator on range (1/2" NPT x 1/2" I.D.)
• I,iquid leak detector or soapy water:
• I,ag bolt or l/2" O.D. sleeve anchor (tor concrete
floo_ only).
*'Ibflon: Registered ti-ademark of DuPont
Loading ...
Loading ...
Loading ...