Loading ...
Loading ...
Loading ...
©
2021 DJI All Rights Reserved.
51
AGRAS T10
User Manual
2. Hold the aircraft horizontally and rotate it 360° around a vertical axis with the aircraft approximately 1.2
m above the ground. Calibration is completed when the app displays that calibration was successful.
3. If the app displays a tilted aircraft, it indicates that the horizontal calibration failed. Users should tilt
the aircraft and rotate it horizontally. Calibration is completed when the app displays that calibration
was successful. To reduce the number of rotations required, the aircraft should be tilted at least 45°.
4. If calibration continues to fail, recalibrate the compass from Step 1.
Starting and Stopping the Motors
Starting the Motors
The Combination Stick Command (CSC) listed below is used to start and stop the motors. Make sure
you perform the CSC in one continuous motion. The motors begin to accelerate at an idle speed.
Release both sticks simultaneously. Take off immediately once the motors are spinning, or else the
aircraft may lose balance, drift, or even takeoff by itself and risk causing damage or injury.
OR
Stopping the Motors
There are two methods to stop the motors.
1. When the aircraft has landed, push and hold the throttle stick down. The motors will stop after three
seconds.
Throttle Stick (left stick in Mode 2)
Loading ...
Loading ...
Loading ...