D-Link DAP-2020 User Manual

Loading ...

39D-Link DAP-2020 User Manual

Section 3 - Conguration

PPPoE

Select PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a

username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your

computer. The software is no longer needed and will not work through the DAP-2020.

Password:

Service Name:

Reconnection Mode:

Idle Timeout:

MTU Size:

Attain

DNS Automatically:

Set DNS Manually:

DNS Servers:

Clone MAC Address:

Enter your PPPoE user name.

Enter your PPPoE password and then retype the

password in the next box.

Enter the ISP Service Name (optional).

Select Always on, On demand, or Manual.

Enter a maximum idle time during which the

Internet connection is maintained during inactivity.

You may need to change the MTU (Maximum

Transmission Unit) for optimal performance with

your specic ISP. The maximum/default MTU size

is 1492.

Select this option if you want the DAP-2020 to get

the DNS (Domain Name System) server IP address

automatically.

Select this option if you want to manually enter

the DNS Server IP address(es). Fields to enter the

Primary and Secondary DNS server IP addresses will appear after you select this option.

Enter the Primary and Secondary DNS server IP address assigned by your ISP.

The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your PC’s MAC Address

button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended that you change

the default MAC address unless required by your ISP.

Loading ...

D-Link DAP-2020 Wireless N Access Point