Loading ...
Loading ...
Loading ...
30
GAS CHECKS AND ADJUSTMENTS - AIR SETTING
Oven burner
Check the aeration setting of the oven burner and if necessary adjust by following
these procedures. Remove the shelves and vitreous enamelled floor (taking care not to
damage the finishes). To remove the oven floor it may be necessary to remove the door
first and the 3 screws under the bottom edge of the seal. There is also a screw in the
side wall of the oven that if loosened makes the oven floor easy to remove.
Set the flame to maximum and loosen the aeration sleeve fixing screw. Rotate or slide
the aeration sleeve, depending on model, to increase or decrease the air intake. Tighten
the fixing screw. Assembly is a reversal of the above procedure.
GAS CHECKS AND ADJUSTMENTS - LOW FLAME SETTING
Check the low flame setting for each hob burner and the oven burner with the control
engaged in the minimum position.
Hob Burner
Turn the control until it engages in the minimum position and remove the control knob.
Insert a screwdriver in the adjusting screw (located to the side of the gascock shaft). To
increase the flame, turn the adjusting screw anticlockwise. To decrease the flame, turn
the adjusting screw clockwise. Adjust for a minimum, stable and clear flame. ENSURE
THE MINIMUM FLAME WILL NOT BE EXTINGUISHED BY AIR DRAUGHTS.
Oven Burner
Light the oven burner and operate at maximum for 15 minutes. Turn the control until it
engages in the minimum position and remove the control knob. Insert a screwdriver in
the adjusting screw (located to the side of the gascock shaft or in the centre of the shaft).
To increase the flame, turn the adjusting screw anticlockwise. To decrease the flame,
turn the adjusting screw clockwise. Adjust for a minimum, stable and clear flame.
Ensure the minimum flame will not be extinguished when the oven door is closed.
Loading ...
Loading ...
Loading ...