Loading ...
Loading ...
Loading ...
8. ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
To remove the oven bottom:
A. Remove the knurled screws holding down rear of the
oven bottom.
B. Grasp the oven bottom at finger slots on each side.
C. Lift the rear of the oven bottom enough to clear the lip of
the range frame, push it back, and then pull it up and out.
The air adjustment shutter for the top (broil) burner is in the
center of the rear wall of the oven.
shu_er
The shutter for the oven burner is near the back wall behind
the warming drawer. Remove the drawer. See the Care and
cleaning of the range section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward
open or dosed position as needed.
The flames for the top (broil) burner should be steady with
approximately 1"blue cones and should not extend out over
the edges of the burner bane.
To determine if the bottom burner flames are burning properly,
remove the oven bottom. Flames should have approximately 1"
blue cones and, if range is supplied with natural gas, should
burn with no yellow tipping. (With most LP gas, small yellow
tips at the end of outer cones are normal.) Flames should not
lift offburner ports. If lifting is observed, gradually reduce air
shutter opening until flames are stabilized.
- 49 -
9. LEVELING THE RANGE
A. Install the oven shelves in the oven and position the
range where it will be installed.
Io] , _, Lower Raa_S_ _ L°Wge
,eve,e
range
(onsomemodels) (onsomemodels)
B. Check for levelness by placing a spirit level or a cup,
partially filled with water, on one of the oven shelves. If
using a spirit level, take two readings--with the level
placed diagonally first in one direction and then the other.
C. Remove the drawer. See the Care and cleaning of the
range section. The front leveling legs can be adjusted
from the bottom and the rear legs can be adjusted from
the top or the bottom.
D. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level.
E. After the range is level, slide the range away from the
wall so that the Anti-Tip device can be installed.
Loading ...
Loading ...
Loading ...