Loading ...
Loading ...
Loading ...
BURNER CAPS AND HEADS
Burner caps
Lift off when cool. Wash burner
caps in hot, soapy water and
rinse with clean water. You may
scour with a plastic scouring
pad to remove burned-on food
particles.
Slot-
Electrode
Make sure the slot in the
burner head is positioned
over the electrode, Use a
sewing needle or twist-tie
to unclog the small hole in
the burner head.
Burner heads
For proper ignition, make sure
the small hole in the section
that fits over the electrode is
kept open. A sewing needle or
wire twist-tie works well to
unclog it.
The slits in the burner heads I _ _ __
must be kept clean at all times.
Clogged or dirty burner ports or Burner cap is properly
electrodes will not allow the seated.
burner to operate properly.
Any spill on or around an
electrode must be carefully
cleaned. Take care to not hit an
electrode with anything hard or
it could be damaged.
You should clean the burner
caps and burner heads routinely, especially after bad
spillovers, which could clog the openings in the burner
heads. Lift off when cool.
To remove burned-on food, soak the burner heads in a
solution of mild liquid detergent and hot water tbr 2o-3o
minutes. For more stubborn stains, use a toothbrush.
Burner cap is NOT properly
seated.
_0'1'1!: Do not use steel wool or scouring powders to clean the
burners.
Burners will not lite if cap is removed.
After cleaning
Beibre putting the burner caps and heads back, shake out
excess water and then dry them thoroughly by setting in a
warm oven ibr 3o minutes.
Replacement
Replace the burner caps and heads. Make sure that the caps
and heads are replaced in the correct location. There is two
small, one medium, one large, and one extra large round
burner cap.
Smallburnerhead
Medium burner and capassembly Small burner
head andcap
8 headand cap
° I °
O " I " @
O , • C)
Frontof range
Largeburner Extralarge burner
headand cap headandcap
ii!i..............................
-33-
Loading ...
Loading ...
Loading ...