Loading ...
Loading ...
Loading ...
ill
ii!iii!!iiii
..............................i;i_
USING THE CLOCK AND TIMER
To Set the Clock
The clock must be set to the correct time of day for the
automatic oven timing functions to work properly. The time
of day cannot be changed during a timed baking or self-
denning cycle.
1. Touch the CLOCK pad once to set.
Make sure the clock
is set to the correct
time of day.
2. Touch the number pads.
Touch the number pads the same way you read them. For
example, to set 12:34 , touch the number pads 1, 9, 3 and 4 in
that order.
If number pads are not touched within one minute after you
touch the CLOCK pad, the display reverts to the original
setting. If this happens, touch the CLOCK pad and reenter
the time of day.
3. Touch the START pad until the
time of day shows in the display.
This enters the time and starts the
clock.
To cheek the time of day when the display is showing other
information:
Simply touch the CLOCK pad.
To Set the Timer
The timer does not control oven operations. The maximum
setting on the timer is 9 hours and 59 minutes.
1. Touch the TIMER ON/OFF pad.
2. Touch the number pads until the
amount of time you want shows in
the display. The maximum time
that can be entered in minutes is
59. Times more than 59 minutes
should be changed to hours and
minutes. For example, to enter
90 minutes as 1 hour 30 minutes,
touch 1,3 and 0 in that order.
i_l!'l'l!: If you make a mistake, press the TIMER ON/OFF
pad and begin again.
3. Touch the START pad. After
pressing the START pad, SET
disappears; this tells you the time
is counting down, although the
display does not change until one
minute has passed.
4. When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the TIMER ON/OFF pad is
touched.
The 6 second tone can be canceled by following the steps in
the Special features of your oven control section under Tones
at the End of a Timed Cycle.
_ffl'l!: The timer is a minute timer only.
The CLEAR/OFF pad does not affect the timer.
To Reset the Timer
If the display is still showing the time remaining, you may
change it by touching the TIMER ON/OFF pad, then touch
the number pads until the time you want appears in the
display.
If the remaining time is not in the display (clock, delay start
or cooking time are in the display), recall the remaining time
by touching the TIMER ON/OFF pad and then touching
the number pads to enter the new time you want.
To Cancel the Timer
Touch the TIMER ON/OFF pad twice.
Power Outage
If a flashing time is in the display, you have experienced a
power failure. Reset the clock.
Touch the CLOCK pad once to reset. Enter the correct time of
day by touching the appropriate number pads. Touch the
START pad.
- 16-
Loading ...
Loading ...
Loading ...