Kenmore 3634272790 modular cooktop

User Manual - Page 3

For 3634272790.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Preparing for Rnstailation
Positioning the cooktop
The cooktop is designed to look best when centered
in a cabinet it's same width.
The exhaust vent beneath the cooktop must be locat-
ed between wall studs or floor joists so that ductwork
may be installed properly.
At least 6" must be allowed between side edges of
cooktop and adjacent walls.
1/2" Flat area
30"
t5"--" [
6" Min.
to side
Avoid placing cabinets above the cooktop unit, if pos-
sible, in order to reduce the hazards caused by reach-
ing over heated surface units. If cabinets are placed
over the cooktop, the risks can be reduced by installing
a range hood that projects horizontally a minimum of 5
inches beyond the bottom of the cabinets.
If cabinetry is used above cooktop, allow a minimum
30" clearance between the cooking surface and the
bottom of any unprotected cabinet,
If clearance between cooktop and cabinetry is less
than 30'; cabinet bottom must be protected with flame
retardant millboard at least 1/4" thick, covered with 28
gauge sheet steel or 0.020" thick copper. Clearance
between cooktop and protected cabinetry must
NEVER BE LESS THAN 24"
A 15" minimum must be kept from the side edge of
cooktop to the bottom of any cabinet not directly above
cooktop. If clearance is less than 15", adjacent cabi-
nets should be at least 6" from side edge of cooktop.
Preparing the Base Cabinet
This cooktop is designed to fit easily into a variety of
cabinets. However, some cabinets may require modi-
fications.
Preparing a cabinet that is against a wall
In some cabinets, the sides may need to be scooped
or cut down 2" as shown, and the corner braces
removed in order to accommodate the unit.
In 75 cm. and 90 cm. frameless European cabinets,
the back panel may need to be cut down 5" to accom-
modate the unit.
Preparing a peninsula or island type cabinet
In a peninsula or island type cabinet, the sides may
need to be scooped or cut down, and the corner
braces removed in order to accommodate the unit.
2"
Approx.
5" Approx.
for European
cabinets
$ ep 3
Rough Preparation of Junction IBox
IMPORTANT--FOR PERSONAL SAFETY, REMOVE
HOUSE FUSE OR OPEN CIRCUIT BREAKER
BEFORE PREPARING JUNCTION BOX.
install an approved junction box within shaded area
shown in diagram. Junction box must be at least 10½"
below top of cabinet.
Run conductors from residence wiring to junction box
according to local electrical codes.
3
(continued next page)
Loading ...
Loading ...
Loading ...