Kenmore 3634272790 modular cooktop

User Manual - Page 19

For 3634272790.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Radiant Module
How to Insert the iVtodute
1. Be sure the controls
are turned to OFF.
To install the module,
position the plug to
the outside waif of
the cooktop.
2. Slide the module
toward the outlet in the
side of the cooktop
until the plug is pushed
all the way in.
3. Lower the inside edge
of the module into the
cooktop until it is flush
with the cooking sur-
face.
How to Remove the Module
1. Be sure the controls are turned to OFF and the
radiant surface units are cool before attempting to
remove the module.
2. Lift up the tab at the inside edge of the module
until the base clears the opening at the side of the
cooktop.
3. To unplug, hold the module by the front and back
edges and slide toward the center of the cooktop.
Lift out when unplugged.
4. If you are storing modules, do not stack them or
store other materials on top of them. This could
damage the surface of the modules.
General information About
Radiant Modules
The radiant module features heating coils beneath a
smooth glass ceramic surface, The 2 surfaces units
are shown by outlines on the glass.
,, When a surface unit is activated, coils beneath the
unit radiate heat through the glass to the cookware.
The red glow of the coils will be instantly visible
through the glass, it will take the surface unit on the
surface a few moments to heat up. The coil cycles
on and and off to maintain your selected control set-
ting. The coils have temperature limiters to prevent
runaway temperatures.
,, Use the same cookware that you would use with
solid disk elements.
o If you are storing modules, do not stack them or
store other materials on top of them, as damage to
the glass ceramic surface of the radiant module is
likely. Be careful not to damage or bend the electrical
plug.
,, Do not let pots boil dry. Overheated metal can bond
to glass module. An overheated copper pot will leave
a residue that will permanently stain the module.
,, Sliding aluminum cookware across the glass may
leave metal marks. These metal marks will appear
as small scratches. They can be removed with Cook
Top Cleaning Creme and a razor scraper.
o When a surface unit is turned on, the unit can be
seen glowing red within a few seconds. The red glow
will turn on and off (cycling) to maintain the selected
heat setting. With poor cookware, you will see fre-
quent cycling of the unit off and on. Good, flat cook-
ware will minimize the cycling.
o It is safe to place hot cookware from the oven or sur-
face on the glass ceramic surface when it is cool.
Hot cookware will not damage the surface.
iVtelted Materials on the IVlodule
Melted materials (plastic, aluminum foil, sugar or
foods with high sugar content) can cause damage to
the module.
If you accidentally melt anything _ _.,_-
on the module, turn the unit to LO,__>_
wipe the hot module immediately with _.t
several dry paper towels. Wearing an I_J\
oven mitt, hold a razor scraper at a /Y/!
30 ° angle to the module and scrape ,./
the hot spill to a cool area outside of the surface unit.
Be careful not to burn yourself.
Do not attempt further cleaning until the module
surface has cooled. See the Care and Cleaning
section.
NOTE: Be sure to use a new, sharp blade in the razor
scraper. Do not use a dull or nicked blade.
(continued next page)
19
Loading ...
Loading ...
Loading ...