Loading ...
Loading ...
Loading ...
CONTROLS
Surface Cooking With infinite Heat
Controls
At both OFF and HI the control "clicks" into position.
You may hear slight "clicking" sounds during cooking,
indicating the control is keeping the unit at the heat
level you set.
Switching heats to a higher setting always shows a
quicker change then switching to a lower setting.
Push the knob in and turn
in either direction to the
heat setting you want.
Be sure you turn control to
OFF when you finish
cooking.
The surface unit indicator light wilt glow when ANY
heat on any surface unit is on.
Heat Setting Guide
OFF
LO
HI
o a
MEDIUM ,i_ _ MEDIUM
LOW HIGH
MED
HI--Used to begin cooking or to bring water to a boil.
Reduce heat setting after water boils.
MEDIUM HIGH--(Setting halfway between HI and
MED.) Maintains a fast boil on large amounts of food.
IViED--Saute and brown; keeps food at a medium boil
or simmer.
MEDIUM LOW--(Setting halfway between MED and
LO.) Cook after starting at H!; cooks with little water
in covered pan.
LO--Used for long, slow cooking (simmering) to ten-
derize and develop flavors. Use this setting to melt
butter and chocolate or to keep foods warm.
NOTE: The surface Indicator Light may glow between
LO and OFF, but there is no power to the surface
units.
Do not be alarmed by the blower. It will auto-
matically come on when the grill or griddle is
used.
COIL SURFACE
UNIT MODULE
How to insert the Module
1. Be sure the controls
are turned to OFR
To install the module,
position the plug to
the outside wall of
the cooktop.
2. Slide the module toward
the outlet in the side of
the cooktop until the
plug is pushed all the
way in.
\
3. Lower the inside
edge of the module
into the cooktop until
it is flush with the
cooking surface.
How to Remove the Modume
1. Be sure the controls are turned to OFF and the
surface units are cool before attempting to remove
the module.
2. Lift up the tab at the inside edge of the module until
the base clears the opening at the side of the cook-
top.
3. To unplug, hold the module by the front and back
edges and slide toward the center of the cooktop.
Lift out when unplugged.
4. If you are storing modules, do not stack them or
store other materials on top of them. This could
damage the surface of the modules.
14
Loading ...
Loading ...
Loading ...