Loading ...
Loading ...
Loading ...
11. Press START to begin heating the oven.
12. Press CANCEL OVEN (CANCEL UPPER or CANCEL LOWER
on double oven models) to turn off the oven.
To disable Sabbath Mode:
Sabbath Mode will automatically be disabled when a cook time
ends, or can be disabled by pressing Cancel. "Sabbath Mode:
OFF" will appear on screen. To program a new cycle, follow steps
2 - 11 in the "To Use Sabbath Mode" section.
Temperature Calibration
1. From the Setup Menu, touch the button at the right-hand side
of screen beside Temperature Calibration.
2. On double oven models, select which oven to calibrate:
upper or lower.
3. Touch NEXT.
4. Select the temperature offset. Press -1° button if oven seems
too hot or +1° button if oven seems too cold. The oven can
be adjusted +/- 35°E
5. Touch SAVE and the adjustment has been made
Touch Calibration
IMPORTANT: If the buttons on the screen are difficult to touch
accurately, you may need to calibrate the touchscreen. This
process is recommended when the oven is installed under a
counter.
1. From the Setup Menu, touch the button at the right-hand side
of screen beside Touch Calibration.
2. You will be asked to touch and hold 3 targets to calibrate.
3. Touch NEXT.
4. Touch and hold the center of the targets for 2 seconds on the
screen.
5. Test calibration by moving the circle around the screen.
Ensure you can reach all the corners.
6. Touch TRY AGAIN to run calibration again.
7. If CANCEL is touched, the Touchscreen Calibration will be
canceled.
8. Touch SAVE. This will return you to the Setup Menu.
Reset All Settings To Factory Defaults
1. From the Setup Menu, touch the button at the right-hand side
of screen beside Reset All Settings to Factory Default.
2. Touch RESET or CANCEL.
3. If Reset is touched, the following sets will be lost: most used
modes/foods, My Creations, Date/Time, and Language. The
Welcome Guide will appear in order to help you reset these
settings.
Service Information
For more information, see the "Assistance or Service" section.
1. From the Setup menu, touch the button at right-hand side of
screen beside Service Information.
2. Choose ON or OFF for Demo Mode. When Demo Mode is on
the oven will not heat and "Demo Mode" will appear on the
left side of the screen.
3. If CANCEL is touched, the Service Information will go back to
the default setting.
4. Touch SAVE. This will return you to the Setup menu.
OVEN USE
Odors and smoke are normal when the oven is used the first few
times, or when it is heavily soiled.
During oven use, the heating elements will not remain on, but will
cycle on and off throughout oven operation.
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well-
ventilated room.
Aura sum Fo
IMPORTANT: To avoid permanent damage to the oven bottom
finish, do not line the oven bottom with any type of foil or liner.
• For best cooking results, do not cover entire rack with foil
because air must be able to move freely.
• To catch spills, place foil on rack below dish. Make sure foil is
at least 1/2" (1.3 cm) larger than the dish and that it is turned
up at the edges.
IMPORTANT: To avoid permanent damage to the porcelain
finish, do not place food or bakeware directly on the oven door or
bottom.
RACKS
• Position racks before turning on the oven.
• Do not position racks with bakeware on them.
• Make sure racks are level.
Depending on the oven model, you could have flat, offset and/or
roll-out racks. If "f" is after the rack position, the flat rack should
be used. An "o" after the rack position indicates the offset rack
should be used. An "r" indicates the roll-out rack should be used.
For example: 1o, 3f, 5r indicates the use of the offset rack in rack
position 1, the flat rack in position 3, and the roll-out rack in
position 5. Refer to the section for the mode you are using for
specific rack recommendations.
Loading ...
Loading ...
Loading ...