Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 369
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are
replaced as an assembly.
NOTE:
We recommend seeing an authorized dealer for service.
REAR TAIL, STOP, TURN SIGNAL, AND BACKUP
LAMP — IF EQUIPPED
See the following steps to replace:
1. Remove the two screws that pass through the bed
sheet metal.
Tail Lamp Screws
2. Pull the outboard side of the lamp rearward, far
enough to unsnap the two receptacles on the
outboard side of the lamp housing, from the two
plastic snap post retainers in the outer box side
panel.
3. Once removed, locate and rotate the appropriate
socket a quarter turn counterclockwise, then remove
it from the housing.
4. Pull the bulb straight from the socket to replace.
5. To install a new bulb, reverse the procedure above.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
The stop lamp is mounted on the tailgate. If service is
needed, obtain the LED assembly from an authorized
dealer.
LICENSE PLATE LAMPS — IF EQUIPPED
NOTE:
To install a new bulb, reverse the procedure above. When
installing the new bulb, care should be taken to not allow
bare skin to come in contact with the bulb.
See an authorized dealer to replace LED lamps.
TIRES
TIRE SAFETY INFORMATION
Tire safety information will cover aspects of the following
information: Tire Markings, Tire Identification Numbers,
Tire Terminology and Definitions, Tire Pressures, and Tire
Loading.
NOTE:
If your vehicle is equipped with bead-lock wheels, please
refer to your vehicles bead-lock specific part number for
additional information and instructions on mopar.com or
by contacting an authorized dealer.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Always use the correct bulb size and type for replace-
ment. An incorrect bulb size or type may overheat
and cause damage to the lamp, the socket or the
lamp wiring.
8
23_JT_OM_EN_USC_t.book Page 369
Loading ...
Loading ...
Loading ...