Loading ...
Loading ...
Loading ...
16
USE AND CARE
OVEN FITTING OUT
Fit the catalytic panel to the side rack (some
models only)
■ Ensure the panels are placed the correct
way around (with the arrow up): the cutout
ts over the light and the hole for the xing
screw goes to the front of the oven.
■ Fit the rear prongs of the side rack through
the holes in the catalytic panel.
Fit the side racks
■ Slide the rear prongs of the side rack into
the holes “A” at the rear of the oven (g. 9a).
■ Fit the side rack front tab over the xing hole
and tighten the xing screw (g. 9a).
■ Slide in, on the guides, the shelf (g. 9b).
The shelf must be tted so that the safety
notch, which stops it sliding out, faces the
inside of the oven; the guard rail shall be
at the back.
■ To dismantle, operate in reverse order.
Oven tray
■ The oven tray must be correctly placed on
the shaped wire shelf (not the at one) or on
the telescopic sliding shelf supports (g. 9b,
with the sliding supports not on the third level
from the bottom).
CAUTION:
■ This appliance must be used only for the task it has explicitly been designed for, that
is for domestic cooking of foodstuffs. Any other form of usage is to be considered as
inappropriate and therefore dangerous.
■ Do NOT place combustible materials or products on this appliance at any time.
Figure 9a
Figure 9b
Stop notch
Guard rail
or
A
A
Loading ...
Loading ...
Loading ...