Loading ...
Loading ...
Loading ...
e. Connect RED battery cable to positive (+)
battery terminal with hex bolt, flat vcasher,
Iockwasher and hex nut (shown full size below)
found in bag of parts (Fig. 5). Tighten securely,
f, Connect BLACK ground cable to negative (-)
battery terminal with remaining hex bolt, flat
washer, lockwasher and hex nut (shown full
size below) found in bag of parts (Fig, 5).
Tighten securely.
NOTE: IF YOU HAVE AWEAK BATTERY, SEE "START-
ING YOUR TRACTOR WITH A WEAK BATTERY'"
(PAGE 20t.
g. Using the square hole on one side of the battery
support (Fig. 6) insert one battery bolt, head of bolt
down. Fasten the battery bolt to the t erminat guard
using wing nut as shown (Fig. 6). Bolts, nuts, and
terminal guard, shown below, are found in bag of
parts.
h. .Assemble the remaining battery bolt to other side
of battery support and fasten terminal guard to it
with remaining wing nut. Tighten both wing nuts
securely (by hand)) at the same time (Fig. 6).
TERMINAL DOORS
L Replace air intake duct (Fig. 4). Make sure
bottom lip of d#ct sits between battery and lip
of battery tray,
j. Remove plastic from tractor hood and close.
NOTE:
1.
USE TERMINAL ACCESS DOORS (FIG. 6) FOR:
INSPECTION FOR SECURE CONNECTIONS
(TIGHTEN HARDWARE)
2. _NSPECTtON FOR CORROSION
3. TESTING BATTERY
4. JUMPING (IF REQUIRED)
5. CHARGING (IF REQUIRED)
KEEP TERMINAL ACCESS DOORS CLOSED
WHEN NOT iN USE.
DO NOT START ENGINE UNTIL MOWER
SUSPENSION BRACKET HAS BEEN RE-
LEASED, .SEE MOWER AND DRIVE BELT
{LNSTALLAT_ON, PAGE 10,
BATTERY
BOLT
SQ_UARE
HOLE
A SSEIVIBL Y
/ NUT
/
-WASHER
HEX
BOLTS
BLACK
(NEGATIVEI
CABLE
DRAIN
(ON LEFT
REAR SIDE)
FIGURE 5
ERM_NAL
ACCESS
DOOR
TERMINAL
GUARD
\
} TERMINAL
ACCE_ DOOR
Y _OLT
SUPPORT
FIGURE 6
Loading ...
Loading ...
Loading ...