Loading ...
Loading ...
Loading ...
A Y
STEERING WHEEL CAP
HEX LOCK NUT
2 , '1/4" DIA. WASHER
_- STEER|NG
____Jr-__-3,_--_,ยข,/ / WHEEL
FIGURE 3
AIR
INTAKE
DUCT
"\
HOOD
GRILL
FIGURE 4
BATTERY
COMPARTMENT
3. Install Steering Wheel
NOTE: POSITION FRONT WHEEL FORWARD.
a, Use a 3/4" wrench to remove lock nut, and
2 ,. 1/4" diameter washer (shown full size below)
from steering column (Fig. 3).
b. Position steering wheel over steering wheel insert (Fig,
3). BARS OF STEERING WHEEL SHOULD POINT
STRAIGHT ACROSS TRACTOR.
c. Secure steering wheel to steertng column using
2- 1/4"' diameter washer and lock nut (Fig, 3).
Torque to 68 N-m (50 Ft. Lbs.)
d. Snap steering wheel cap in place on steering
wheel, Steering wheel cap found in bag of parts,
4. Check Tires
Reduce tire pressure to 1Kg/cm _ (14 PSi) in front tires
and 0.71 Kg/cm 2 (10 PSi) in reartires. (Tires were
overinflated for shipping purposes.)
5. Install Battery
DO NOT SHORT BATTERY TERMINALS
BEFORE INSTALLING BATTERY, REMOVE
METAL BRACLETS, WRISTWATCH BANDS,
RINGS, ETC.
a. Lift hood from rear sides (Fig. 4).
b. Lift out air intake duct.
c MaRe sure drain tube (Fig. 5) is fastened to drain
hole in battery tray and battery tray is position
ed in hole of battery support.
d. Place battery in plastic tray (battery terminals to
front of tractor) (Fig. 5).
,_ POSITIVE TERMINAL MUST BE CONNEC- 1
,_ TED FIRST TO PREVENT SPARKS FROM
_ENTAL GROUNDmNG.
Loading ...
Loading ...
Loading ...