Loading ...
Loading ...
Loading ...
HEIGHT
KNOB
b_
Drive so that clippings are discharged onto the area
that has been cut, Have the cut area to the r_qht of
the machine. This will result in a more even distri-
bution of clippings and more uniform cutting,
e,
When mo wing large areas (Fig 17), start b y turning
to the right so that the chpptngs wH/ discharge away
from shrubs, fences driveways, etc, After one or
two rounds, mow in the opposite dzrection making
left hand turns until f/nfshed
GEAR
CONTROL
LEVER
FIGURE 15
YRUNNER
DISCHARGE
GUARD
FIGURE 16
FIGURE 17
CAUTION: NEVER RUN THE ENGINE WITHOUT AiR-
INTAKE DUCT INSTALLED (FIG. 4). MAKE
SURE BOTTOM LIP OF AIR INTAKE DUCT
SITS BETWEEN BATTERY AND LIP OF
BATTERY TRAY,
4, Mowing Tips
NOTE: TIRE CHAINS CANNOT BE USED WITH THE
MOWER HOUSING ATTACHED,
I & READ THE "'SAFETY RULES" CAREFULLY
BEFORE OPERATING YOUR MOWER.
REFER TO PAGE 2.
a Use the runner on the R,H. side as a guide; the blade
cuts approximately2,54 cm (1 inch) outside the runner
(Fig. 16).
d. lf grass is extremely tall, it should be mowed twice,
The first time cut relatively high," the second time
to the desired height,
e. The left hand side of mower should be used for
trimming,
f. Do not mow tall, dry grass over 15.25 cm (6 inches)
tall. tt is a fire hazard.
5. Operating The Tractor On HilfS
L _ DO NOT DRtVE UP OR DOWN H_LLS WiTH
SLOPES GREATER THAN 15 ° AND DO
NOT DRIVE ACROSS ANY SLOPE. REFER
TO PAGE 5!.
a. Move gear shift lever to "' 1ST" gear before starting
up or down hilfs.
b, AVOID STOPPING OR SHIFTING ON HILLS,
c, If slowing is necessary, move throttle control lever
to slower position.
LEAVE ENOUGH ROOM WHEN STOP-
PiNG AND STARTING TO ALLOW SLIGHT
TRACTOR ROLL DOWNHaLL AS CLUTCH/
8RAKE PEDAL MOVES THROUGH CLUTCH
POSITION,
d. If stopping is absolutely necessary push clutch/brake
pedal quickly to brake position and engage parking
brake.
e. To restart tractor movement, make sure tractor is in
the lowest speed range ("1ST'" Gear) and that you
have allowed room to roll slightly downhill. Depress
clutch/brake full. Disengaged parking brake and
release clutch/brake pedal SLOWLY to start tractor
movement.
f. Make all turns gradua#V.
t4
6, Rip-Up Discharge Guard
Your mower has a flip-up discharge guard (Fig. t6) for
door or gate clearance when held in raised position.
MAKE SURE ATTACHMENT CLUTCH SWITCH]
_ 18 IN °D_SENGAGED" POSmTaON AND |
8LADES NAVE STOPPED BEFORE RAiSiNG |
DISCHARGE GUARD _DEFLECTORL NEVER |
OPERATE P_OWER WITHOUT #iSCHARGE |
Loading ...
Loading ...
Loading ...