Loading ...
Loading ...
Loading ...
ADJUSTMENT
[
WHEN MOUNTING TIRES, UNLESS BEADS
ARE SEATED, OVER iNFLATiON CAN
CAUSE AN EXPLOSION,
12. Rear Wheel Repla¢ement
For rear wheel replacement, follow instructions under "TIRE
CARE, "page 24.
Coat axle with grease to prevent corrosion or rust accumulation
and eventual seizing of wheel hub to axle sha&
WHEN REPLACING WHEELS ON THE
TRACTOR THEY MUST BE MOUNTED
WITH THE LONG HUB SiDE TOWARD THE
CENTER OF THE TRACTOR. INCORRECT
INSTALLATION COULD AFFECT LATERAL
STABILITY. (SEE FIG, 46),
t u _ I-_--'.
_J
!
UB _ FIGURE 46
13. Transaxte Shifter Linkage Positioning and Adjust-
ment
The transaxle should be in neutral when the gear shift lever is in
the neutral (lock gate) position (Fig, 47). The adjustment is preset
at the factory; however, if adjustment is needed, proceed as
follows:
a" Make sure transaxte is in neutral.
b, Using a 7/16" wrench, !oosen two (2) locknuts on tie rod
(Fig, 48 - inset).
c. Turn center rod (Fig, 48 - inset) until gearshift lever falls
into neutral lock gate on fender console (Fig. 47).
d. Tighten ldd_nuts securely.
14. Storage
Remove mowerfrom tractorfor winter storage. When mower is to
be stored for a period of time, clean it thoroughly, remove all dirt,
grease, leaves, ete., give blades and underside of housing a good
coat of grease or rust preventative. Store in a clean dry area.
a, Fuel System
It is important to prevent gum deposits from forming in essential
fuel system parts such as the carburetor, fuel filter, fuef hose, or
tank during storage. Also, experience indicates that alcohol
blended fuels (called gasohol or using ethanol or methanol) can
attract moisture which leads to separation and formation of acids
during storage, Addic gas can damage the fuel system of an
Engine while in storage. To avoid engine problems, the fuel
system should be emptied before storage of 30 days or longer.
b. Engine Oil
Drain (with engine warm) oil and replace with clean ngine oil,
(see chart on page 15).
c, Cylinders
1. Remove spark plugs.
2, Pour 29,5 cc (one ounce) of oil through spark plug
hole into cylinder,
3, Turn ignition key to "START" position for a few
seconds to distribute oil.
4, Replace w#h new spark plugs.
d, Battery
1. Prior to storage, clean terminals and top of battery.
2. Disconnect cable from positive side of battery,
After a period of time in storage, battery may require recharging.
e. General Cleaning
Clean engine, battery, seat, finish, etc. of all fore_n matter,
L Store in a clean, dry area
GEAR SHIFTLEVER
NEUTRAL LOCK GATE
FIGURE 47
TRANSAXLE
H
FIGURE 48
25
Loading ...
Loading ...
Loading ...