Loading ...
Loading ...
Loading ...
13
ASSEMBLY
BATTERY REMOVAL
WARNING
Battery posts, terminals, and related accessories contain
lead and lead compounds. Wash hands after handling.
The battery is located beneath the seat frame. To remove
the battery:
1. Remove the battery hold down bracket by pushing the
hooked end out of the tab on the fender to the right side of
the battery. Then flip the battery hold-down bracket up to
free the battery. See Figure 15.
Figure 15
2. Remove the bolt and hex nut securing the black negative
battery lead to the negative battery post (marked NEG). Move
the cable away from the negative battery post.
3. Remove the bolt and hex nut securing the red positive battery
lead to the positive battery post (marked POS).
4. Carefully lift the battery out of the tractor.
5. Install the battery by repeating the above steps in the
reverse order.
CHARGING THE BATTERY
Test and, if necessary, recharge the battery after the tractor has
been stored for a period of time.
• A voltmeter or load tester should read 12.7 volts (DC) or
higher across the battery terminals. See Figure 16.
Voltmeter
Reading
State of
Charge
Charging
Time
12.7 100% Full Charge
12.4 75% 90 Min.
12.2 50% 180 Min.
12.0 25% 280 Min.
Figure 16
• Charge the battery with a 12-volt battery charger at a
MAXIMUM rate of 10 amps.
Adjusting the Seat
KNOB ADJUST OR BOLT ADJUST
To adjust the position of the seat, remove the adjustment knob
or 9/16” bolt (a) on the bottom of the seat (b). Slide the seat (b)
forward or backward as desired. Reinstall the adjustment knob
or 9/16” bolt (a). See Figure 4.
LEVER ADJUST
To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Figure 17.
Figure 17
Oil
NOTE: Your tractor is shipped with oil in the engine. However,
you MUST check the oil level before operating. See the Engine
Operator’s Manual for instructions on checking, adding and
changing oil.
CAUTION
Always check the engine oil level before each use as
instructed in the Engine Operator’s Manual. Add oil as
necessary. Failure to do so may result in serious damage
to your engine.
Loading ...
Loading ...
Loading ...