Loading ...
Loading ...
Loading ...
W415-1407 / 11.20.14
35
EN
6.5 LOG PLACEMENT
F. Finally, align the
rectangular peg on log
#6 with the notch on the
front right portion of the
burner.
NOTE: Decorative brick panels must be installed before the logs. See installation instructions supplied
with the panel kit.
B
C
D
A
Glowing embers are NOT recommended. The burner has been designed to achieve maximum glow without
embers.
E
F
D. Place log #4 with the
charred branch facing
inward. Position the pin
in log #4 into the hole on
the right of log #2.
A. Place the rear log #1 onto
the locating studs along
the back edge of the
PHAZERAMIC™ burner.
B. Position log #2 in the
2 locating holes behind
the andirons.
C. Place log #3, with the
charred branch facing
inward. Position the pin
in log #3 into the hole
on the left of the log #2.
E. Place log #5 so the
locating hole on the
bottom of the log sits on
the screw and spacer.
6.6 GLOWING EMBERS
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
The individual logs can be easily identifi ed by the numbers cast on the underside of each log.
Phazer
TM
logs and glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect
that is different in every installation. Take time to carefully position the glowing embers for a maximum glowing
effect. During the initial use of the appliance, log colours may vary. During the initial use of the appliance the
colours will become more uniform as colour pigments burn in during the heat activated curing process.
Loading ...
Loading ...
Loading ...