Loading ...
Loading ...
Loading ...
4. Cut the plastic tie holding the UprightWire Harness (98) in
the right Upright (69). Have a second person hold the
Handrails (66) near the Uprights as shown. Connect the
Upright Wire Harness (98) to the wire harness extending
from the Console Base (81). Insert the connectors and the
Upright Wire Harness into the hole in the right Upright.
Set the Handrails (66) on the Uprights (69), being careful
not to pinch the Upright Wire Harness (98).
5. Insert two Handrail Bolts(78) with Handrail Washers (77)
into the right Upright (69) and the right Handrail (66). Be
careful not to damage the Upright Wire Harness (not
shown). Next, liftthe rightHandrail (66) slightlyand align
the Boltswiththe holesin the Handrail.Thread the Bolts
intothe Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown)in the same way.
Tighten allfour Handrail Bolts (78).
6. Make sure that all parts are properly tightened before
you use the treadmill. Place a mat beneath the tread-
mill to protect the floor. Foryourbenefit, familiarize
yourselfwith the informationon pages 27 end 28,
66
78
If you purchase the optional chest pulse sensor (see
page 24), follow the steps below to install the receiver
and the short jumper wire included with the chest pulse
sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated screws from the Console Back (A).
Important: The screws may be different lengths. Keep
track of which screws were removed from which holes,
Remove the Console Back.
2. Peel the paper offthe pad on the bottom ofthe Receiver
(B). Turn the Receiver so the cylinder is on the side
shown, and pressthe Receiver intothe bottomofthe
Console Base (D) inthe indicatedlocation.
3. Connect the includedShort JumperWire (E) to thewire on
the Receiver (B). Connect the other end of the Short
Jumper Wire to the PLS2 jack on the back of the Console
(C). If there is a wire already plugged intothe PLS2 jack,
unplug it. Note: The other wires included with the receiver
may be discarded. The wire tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattachthe Console (C) with thescrews. Important: If the
screws are not put back into the same holes from which
they were removed, the Console will be damaged.
3
/
Screws
,linder
D
C
\
\
PLS2
Jack
7
Loading ...
Loading ...
Loading ...