Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-
free at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make surethat the power cord is plugged intoa surgesuppressor,and that the surgesuppressor
isplugged intoa properlygroundedoutlet(see page 8). Useonlya single-outletsurgesuppressor
thatmeets all ofthe specificationsdescribedon page 8. Important:The treadmillis notcompatible
with GFCI-equipped outlets.
b. Afterthe power cordhas been plugged in, make sure thatthe key isfully insertedinto theconsole.
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
c
Tripped_ Reset_
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuit breaker located on the treadmillframe near thepower cord(see c. above). If the
circuitbreaker has tripped,waitfor five minutesand then pressthe switchback in.
b. Make sure thatthe power cord isplugged in. If the power cordis plugged in, unplug it, waitfor five
minutes, and then plug it back in.
c. Remove the key from the console.Reinsert the key fully intothe console.
d. If the treadmill still will not run, please call our Customer Service Department, toll-free.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key fromthe consoleand unplug the
power cord. Carefullytipthe treadmilldownas shown
indrawinga. Remove the 1"Screws (33) and 2"
Screws (3) from the hood. Raise the Uprights(69) and
carefully remove the hood.
Locate the Reed Switch (10) and the Magnet (7) on
the left side of the Pulley (8). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". If necessary, loosen the Screw
(27) and move the Reed Switch slightly. Retighten the
Screw, Re-attach the hood, making sure the screw are
in their same holes. Run the treadmill for a few min-
utes to check for a correct speed reading.
1/8"-- =---
27_ "-. __--8 __
104 "7
Top --
View
27
Loading ...
Loading ...
Loading ...