Loading ...
Loading ...
Loading ...
© 2020 United States Stove Company
7
SAFETY INFORMATION
19. Do not use this heater for burning trash or
cooking. Never place matches, paper, garbage
or any other material on top of logs or into the
ames.
20. Do not install or operate this heater in areas
where impurities in air exist (such as tobacco
smoke or heavy cooking grease). Particles from
impurities may discolor walls.
21. Due to high temperatures, appliance should be
located out of trafc and away from furniture
and draperies.
22. Children and adults should be alerted to hazards
of high surface temperature and should stay
away to avoid burns or clothing ignition.
23. Young children should be carefully supervised
when they are in same room with appliance.
24. An unvented room heater having an input
rating of more than 10,000 Btu per hour shall
not be installed in a bedroom or bathroom.
25. The appliance and its appliance main gas valve
must be disconnected from gas supply piping
system during any pressure testing of that
system at test pressure in excess of 1/2 psi (3.5
kPa).
26. The appliance must be isolated from gas supply
piping system by closing its equipment shutoff
valve during any pressure testing of gas supply
piping system at test pressures equal to or less
than 1/2 psi (3.5 kPa).
27. A replace screen must be in place when
appliance is operating and unless other
provisions for combustion air are provided,
screen shall have an opening(s) for introduction
of combustion air.
The replace needs to be prepared before installing
the heater.
A. Turn off the gas supply to the replace.
WARNING:
BEFORE INSTALLING IN A SOLID-FUEL
BURNING FIREPLACE, CHIMNEY FLUE AND
FIREBOX MUST BE CLEANED OF SOOT,
CREOSOTE, ASHES AND LOOSE PAINT BY A
QUALIFIED CHIMNEY CLEANER.
WARNING:
ANY OUTSIDE AIR DUCTS AND/OR ASH DUMPS
IN FIREPLACE SHALL BE PERMANENTLY
CLOSED AT TIME OF APPLIANCE
INSTALLATION.
B. Read the following sections before installing
your unit; Installation In A Solid-Fuel Burning
Fireplace, and Producing Adequate Air For
Combustion And Ventilation.
WARNING:
CUTTING ANY SHEET-METAL PARTS OF
SOLID FUEL BURNING FIREPLACE OR LISTED
VENTLESS FIREBOX ENCLOSURE IN WHICH
UNVENTED FIREPLACE INSERT IS TO BE
INSTALLED IS PROHIBITED.
NOTE: IF FACTORY BUILT FIREPLACE HAS NO GAS
ACCESS HOLE(S) PROVIDED, AN ACCESS HOLE
OF 1.5 inch (37.5mm) DIAMETER OR LESS MAY BE
DRILLED THROUGH LOWER SIDES OR BOTTOM OF
FIREBOX IN A PROPER WORKMANLIKE MANNER.
THIS ACCESS HOLE MUST BE PLUGGED WITH
NON-COMBUSTIBLE INSULATION AFTER GAS
SUPPLY LINE HAS BEEN INSTALLED. REFRACTORY,
GLASS DOORS, SCREEN RAILS, SCREEN MESH,
AND SOLID-FUEL LOG GRATES (IF APPLICABLE)
CAN BE REMOVED FROM FIREPLACE BEFORE
INSTALLING UNVENTED FIREPLACE INSERT.
This is an unvented gas-red heater. It uses
air (oxygen) from room in which it is installed.
Provisions for adequate combustion and
ventilation air must be provided. Refer to the
section,” Producing Adequate Air For Combustion
And Ventilation" in this manual. This appliance
may be installed in an aftermarket, permanently
located, manufactured (mobile) home, where
not prohibited by local codes. This appliance is
only for use with type of gas indicated on rating
plate. This appliance is not convertible for use
with other gases.
Loading ...
Loading ...
Loading ...