Loading ...
Loading ...
Loading ...
© 2020 United States Stove Company
19
WARNING:
WHEN THE APPLIANCE IS INSTALLED
DIRECTLY ON CARPETING, TILE OR OTHER
COMBUSTIBLE MATERIAL, OTHER THAN
WOOD FLOORING, THE APPLIANCE SHALL
BE INSTALLED ON A METAL OR WOOD PANEL
EXTENDING FULL WIDTH AND DEPTH OF THE
APPLIANCE.
FREESTANDING LEGS INSTALLATION
To make this model free standing using cast legs,
follow the instructions below:
1. Place heater on its back.
2. Your heater is equipped with four leg mounting
nuts. Place a leg at each nut and secure leg with
bolts provided.
3. The legs are equipped with leveling bolts
needed for leveling adjustments.
4. Stand heater to the upright position. Place
heater in the desired location. At this point,
you may want to secure pedestal to oor with
screws or an “ell” bracket.
5. Hook up the gas supply line. Check for leaks with
mild soapy water (see “Installation Clearances
and Gas Connection” section of this manual).
ALCOVE INSTALLATION
READ ENTIRE MANUAL BEFORE INSTALLING
HEATER.
1. For clearances see below. The minimum must
be met.
2. For Installation and Gas Hookup Connection
(see the “Gas Connection” section of this
manual).
CAUTION:
THE INSTALLATION MUST CONFORM WITH
LOCAL CODES OR IN ABSENCE OF LOCAL
CODES, WITH NATIONAL FUEL GAS CODE,
ANSI Z223.1/NFPA54.
WARNING:
DO NOT USE THIS HEATER IF ANY PART HAS
BEEN UNDER WATER. IMMEDIATELY CALL A
QUALIFIED SERVICE TECHNICIAN TO INSPECT
ROOM HEATER AND TO REPLACE ANY PART
OF CONTROL SYSTEM AND GAS CONTROL
WHICH HAS BEEN UNDER WATER.
WARNING:
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE
CAN CAUSE PROPERTY DAMAGE, PERSONAL
INJURY OR LOSS OF LIFE. REFER TO THIS
MANUAL.
WARNING:
ANY CHANGE TO THIS HEATER OR ITS
CONTROLS CAN BE DANGEROUS.
*ALL DIMENSIONS ARE MINIMUM TO COMBUSTIBLE WALL
1-1/2”
7” 7”
1-1/2”
24”
INSTALLATION
Loading ...
Loading ...
Loading ...