Loading ...
Loading ...
Loading ...
© 2020 United States Stove Company
11
Before operating this appliance, proceed through
the following checklist.
1. Read and understand these instructions before
operating this appliance.
2. Check that there are no gas leaks. If you smell
gas do not attempt to light this appliance.
3. Verify that log placement is correct.
WARNING:
ANY CHANGE TO THIS HEATER OR ITS
CONTROLS CAN BE DANGEROUS.
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS
EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL
INJURY OR LOSS OF LIFE.
LIGHTING INSTRUCTIONS SIT-
MILLIVOLT VALVE FOR YOUR SAFETY
READ BEFORE LIGHTING
A. When lighting the pilot follow these instructions
exactly. If piezo fails, then light pilot using
matches. Refer to Manual Lighting Instructions.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to
the oor because some gas is heavier than air
and will settle to the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the re
department.
C. Use only your hand to push in or turn the gas
knob. Never use tools. If the knob will not push
in or turn by hand, don’t try to repair it. Call a
qualied service technician. Force or attempted
repair may result in a re or explosion.
D. Do not use this appliance if any or part of it has
been under water. Immediately call a qualied
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
WARNING:
FIREPLACE SCREENS MUST BE CLOSED WHILE
THE APPLIANCE IS IN OPERATION.
LIGHTING INSTRUCTIONS
1. STOP! Read all safety information.
2. Make sure the manual shutoff valve is fully
closed. If equipped with a thermostat, set it to
the lowest setting.
3. Turn off all electrical power to the appliance.
4. Open access door located at the bottom front
of the appliance.
5. Push in gas control knob slightly and turn
clockwise to the “Off” position.
NOTE: Knob cannot be turned from “Pilot” to “Off”
unless knob is pushed in slightly. Do not force.
REMOTE CONTROL O
R
WALL THERMOSTAT
IN
L
O
H
OUT
O
P
I
L
T
I
O
F
F
O
N
CONTROL
KNOB
HI/LOW KNOB
PILOT
VALVE
6. Wait (5) ve minutes to clear out any gas.
Then smell for gas, including near the oor. If
you smell gas, STOP! Follow “B” in the safety
information section of this manual. If you don’t
smell gas, go to the next step.
7. The pilot is located in front of the rear log and
burner on the right-hand side of the appliance.
Fully open the manual shutoff valve.
8. Press in and turn the knob on gas control
counterclockwise to “PILOT” and continue
pressing in knob for (15) fteen seconds.
9. With the control knob pressed in, push down
(in) and release the ignitor button (ignitor
button is located on the front left-hand side of
the appliance). This will light the pilot. If needed,
keep repeating this step until pilot lights.
10. Keep the control knob pressed in for (1) one
minute after lighting pilot. After (1) minute,
OPERATING INSTRUCTIONS
Loading ...
Loading ...
Loading ...