Loading ...
Loading ...
Loading ...
MAINTENANCE
DEPTH CONTROL KNOB ADJUSTMENTS
See Figure34.
The depth control knob is spring loaded against hex nut to
prevent router motorfrom accidentally separating from router
base. If depth control knob is tumed too far up depth
adjustment rod, the spring will cause depth control knob to
pop off before hex nut. Do not remove hex nut. It should
remain on depth adjustment rod at all times. This is
especially important when using router upside down on a
router table.
TO REPLACE DEPTH CONTROL KNOB:
1. UNPLUG YOUR ROUTER.
II
WARNING:
Failure to unplug your router could result in accidental
starting causing serious injury.
2. Turn hex nut countemlockwise until 1/4 in. of threads
are remaining at the top of depth adjustment rod.
3. Place compression spring on top of hex nut as shown
in figure 34.
4. Place depth control knob on top of compression spring
and align tabs on depth control knob with flats on hex
nut.
5. Carefully compress spring by pushing down on top of
depth control knob.
6. With spring compressed, thread depth control knob
clockwise onto depth adjustment rod.
7. Turn depth control knob until desired depth of cut is
reached.
Do not replace depth control knob without compression
spring,
DEPTH
CONTROL
DEPTH
ADJUSTMENT
ROD
COMPRESSION
1/4
FLATS _
WASHER TABS
WARNING:
Replacing depth controlknobwithout compression spring
could resultin depth controlknob and hexnut vibrating off
depth adjustment rod during use. This situation could
cause motor to separate from router base, resulting in
possible serious personal injury.
Fig. 34
i
Page 23
Loading ...
Loading ...
Loading ...