Loading ...
Loading ...
Loading ...
OPERATION
ROUTING WITH OPTIONAL ROLLER GUIDE
See Figures 26 and 27.
An optional roller guide is available for use with your router.
Itisuseful for routing uneven edges and trimming laminates.
The roller guide attaches to the guide holder as shown in
figure 26. Itcan beadjusted inand out aswell as upand down.
The rollerguide ridesagainst the uncutedge oftheworkpiece.
When routinga decorative groove along an uneven edge, the
distancefrom rollerguide tocutter should bethe same as the
distance from the desired cut and the edge of theworkpiece.
Fine adjustments can be made with the edge guide adjust-
ment knob on guide holder. Tighten wing bolts securely.
When routing, keep roller pressed tight against edge of
workpiece. Carefully follow desired line of cut so that the
distance between the cut and the edge does not vary.
When trimming laminates with the rollerguide, use a straight
cutting bit or a roundnose bit. Position the rollerguide even
with the inside cutting edge of router bit. The roller guide
follows the edge of the workpiece while the bit trims off the
overhanging laminate. See Figure 27.
ROUTING WITH OPTIONAL GUIDE BUSHINGS
See Figures 28 and 29.
You can accurately duplicate curves and complex shapes by
fitting your router with optional template guide bushing that
extends below the subbase. The router bit passes through
the guide bushing. The guide bushing then rides against a
template.
TO INSTALL TEMPLATE GUIDE BUSHING:
1. UNPLUG YOUR ROUTER.
Failure to unplug your router could result in accidental
starting causing serious injury.
2. Place router upside down on workbench.
3. Place template guide bushing in recessed portion of
router base as shown in figure 28.
4. Align the cutouts in guide bushing with threaded holes
in base.
5. Secure guide bushing to router base with roundhead
screws provided.
6. Tighten screws securely.
l.w...,.oj
Failure to tighten screws could cause bit to come in
contact with bushing resulting in serious injury.
LAMINATE
OPTIONAL ROLLER GUIDE
OPTIONAL "
TEMPLATE
GUIDE BUSHING
SCREW
ALIGN
CUTOUTS
WITH
IN
ROUTER BIT
Fig. 27
Page 18
Loading ...
Loading ...
Loading ...