Loading ...
Loading ...
Loading ...
OPERATION
WARNING:
Always wear safety goggles or safety glasses with side
shields when using your router. Failure to do so could
result in dust, shavings, chips, loose particles, or foreign
objectsbeingthrown in youreyes causing possiblesedous
injury. Ifoperation isdusty, also wear a face or dust mask.
i
LOCK-ON BU'I'I"ON
See Figure 13.
The on-off trigger ofyour router is equipped with a lock-on
feature which is convenient when operating for extended
periods of time. The lock-on button is located in the upper
portion of the on-off trigger. It works similar to a rocker
switch. To lock on, fully depress on-off trigger, then de-
press lock-on button in top of on-off trigger and release.
You will feel the lock-on button as it snaps on-off trigger
into took position. To release the took, depress protruding
portion of the lock-on button.
WARNING:
Before connecting muter to power supply source, always
check to be sure switch isnot inlock-on position. Failure
to do socould result in accidental starting ofyour router
causing possible serious injury.
ROUTING
See Figure 14.
For ease of operation and maintaining proper control, your
routerhas two handles, one on each side of the router base.
When using your router hold it firmly with both hands as
shown in figure 14.
Beforestarting router, make sure cutter is securely tightened
in collet nut and that depth of cut is properly set.
Turn router on and let motor build to its full speed, then
gradually plunge or feed cutter intoworkpiece. DO NOT let
the cutter contact workpiece before turning on router and
allowing it to develop full speed.
Remain alert and watch whatyou are doing. DO NOT operate
router when fatigued.
FEED DIRECTION
When routing, the cutter rotates clockwise. Therefore, you
should feed the router into the workpiece from left to right.
When fed from leftto right,the rotationof the cutter pullsthe
router against the workpiece. Iffed inthe oppositedirection,
the rotation forces of the spinning bit willtend to throw the
router away from the workpiece. This could cause loss of
control of your router.
RATE OF FEED
IMPORTANT: The whole"secret" ofprofessional mutingand
edge shaping lies in making a careful set-up for the cutto be
made and in selecting the proper rate of feed.
The proper rate of feed depends on several factors: the
hardness and moisture content of the wood, the depth of cut,
and the cutting diameter of the bit. When cutting shallow
grooves in soft woods such as pine, a faster rate of feed can
be used. When making deep cuts in hardwoods such as oak,
a slower rate of feed will be required.
The best rate of feed is one that does not slow down the router
motor more than one-third of its no-load speed. If the router
isfed too fast, itwilltake large chips out of the wood and leave
gouge marks. Ifthe router isfed too slow, itwill scorch orburn
the wood.
P_n_ 1_
Loading ...
Loading ...
Loading ...