Loading ...
Loading ...
Loading ...
79
8.2: Wine Coolers:
Wine coolers have slide rail shelving with 7 pairs of slide rails on each side of the interior
cabinet.
1. Remove all shelving.
2. Remove decorative plastic snap caps.
a. The plastic cap located at the top center of the coil cover is hinged on one side; it
is slightly larger than the remaining plastic decorative snap caps.
3. Remove screws around the perimeter of the coil cover.
4. Carefully remove the coil cover and disconnect the evaporator fan and thermistor wires
as needed.
8.3: Refrigerated Drawers
NOTE: Refer to Section 19 for a Service Bulletin regarding a mullion heater kit.
To gain access of the evaporator and associated components located behind the coil cover.
1. Remove both top and bottom drawer (see section 7.4.1: Drawer Removal).
2. Disconnect the communication cable at the rear of the top drawer.
3. Remove the mullion bracket screws. (see section 15: SERVICE KITS for additional
information).
a. Remove the two top sheet metal screws securing the right hand mullion bracket
to the cabinet. Loosen the rear screw. The mullion bracket will stay with the
mullion when it is removed.
b. Remove the sheet metal screws on the top and bottom of the left hand mullion
bracket. The mullion bracket will stay attached to the cabinet.
Loading ...
Loading ...
Loading ...