Loading ...
Loading ...
Loading ...
192
19.2.3.6 Removing the High Side Thermistor
1. The base assembly can be slid out 8-10” to help this conversion. (see section 5 for
guidance). Remove both the upper and lower access covers on the rear of the ice
machine to gain access.
2. Locate the thermistor connected to the liquid line at the filter drier inlet.
3. Cut the nylon zip tie holding the thermistor to the evaporator plate.
4. Disconnect the bad thermistor at the main power board connector plug and remove.
19.2.3.7 Installing the High Side Thermistor
1. Attach the new thermistor onto the same liquid line position (filter/drier) and firmly
secure with the zip tie.
At the time of this publication, the bin thermistor is a one piece assembly. Replacing the
thermistor will require removing the upper and lower rear panels, the interior escutcheon
panel, deflector panel, grid cutter, and the water reservoir.
Care in routing the thermistor wire is a concern to ensure that proper wire length is needed to
make the connection on the main power board.
DO NOT pull on the thermistor wire, this could cause damage to the replacement thermistor.
Bin sensor
location.
Loading ...
Loading ...
Loading ...