Loading ...
Loading ...
Loading ...
56
6.2.4: Control Board Installation
1. Replace the two connectors, previously removed, to the correct location on the main
board.
2. Prior to reinstalling the power board locate the slotted tab on the bottom of the
machine compartment.
3. Next locate the notched recess on the bottom of the control bracket.
4. Upon assembly, the notched recess on the control bottom needs to slide into the
slotted tab on the machine compartment.
5. Reattach the assembly to the rear machine compartment flange with the screw
previously removed.
Return the leveling leg to its correct position.
6.3: Cabinet and Defrost Thermistors
WARNING
Prior to removing the access cover to the machine compartment, disconnect the
supply voltage to the appliance; failure to do this could result in an electrical
shock or possible death.
6.3.1 Thermistor (Sensor)
The control thermistor senses the interior temperature allowing the control to adjust and
properly display the interior temperature. The thermistor is located at the mid, left hand wall.
The thermistor is covered with a plastic shield to prevent accidental damage.
The thermistor can be checked by use of a multi-meter with the ability to read resistance. Refer
to the resistance chart.
6.3.2: Check the Thermistor:
The main cabinet and defrost thermistor harnesses from the control board are foamed in place.
The recommended method to ohm the thermistor is to remove the thermistor connector at the
control board and take the reading.
For thermistor replacement; the cabinet thermistor connector is located in front of the
evaporator cover, the defrost thermistor connector is located behind the cover.
Loading ...
Loading ...
Loading ...