Loading ...
Loading ...
Loading ...
216
Remove both upper and lower, rear access panels.
Disconnect the door sensor switch.
Remove the toe grill and access panel from the front of the machine.
Remove screws from all four corners that secure the cabinet assembly to the
base assembly.
Remove these following components:
i. Fill valve, drain valve, “Y” drain connection, and door sensor switch.
5. Install sealed system access valves and recover refrigerant.
6. Disconnect and cap the suction line from the compressor and the capillary tube from
the drier.
7. Slowly slide mechanical base assembly out from the rear of the appliance.
8. Disconnect any electrical harness that restricts your progress.
9. Unsolder and remove the discharge and liquid lines from the condenser.
10. Using a 3/8” nut driver or socket, remove (1) 3/8” nut securing the outside condenser
mounting bracket to the mechanical base. The inner mounting bracket can remain, as
the condenser should slide in and out with the bracket remaining in its current
position.
11. The condenser assembly can now be removed from the base assembly.
12. It is advisable that the un-soldered copper tubes be capped if the system will be
exposed to the atmosphere for any length of time.
Unsolder the condenser at these two
points.
Loading ...
Loading ...
Loading ...