Loading ...
Loading ...
Loading ...
146
16.11.1.2: Ice Maker Test Cycling
Test cycling of the ice maker can be achieved by turning the motor gear counter-clockwise until
the holding switch circuit is complete. All components of the ice maker should function to
complete the cycle.
The timing gear should not be turned as this will damage the ice maker.
16.11.1.3: Water Flow Volume
The water fill adjustment screw will change the fill volume by changing the fill time. One full
turn is equal to 20cc (.68 oz.). The correct fill is between 90 and 120 cc (3.0 – 4.0 oz.).
When replacing a water valve, the fill volume must be checked.
These ice makers are factory preset for a flow rate of .34 gpm (gallons per minute).
PLEASE REFER TO THE SERVICE DATA SHEET INSIDE THE ICE MAKER COVER FOR
ADDITIONAL INFORMATION.
Adjusting the water fill can be
accomplished by turning the adjustment
screw clockwise (+) to increase or counter
clockwise (-) to decrease.
Fill Adjustment
Ice maker with the cover removed.
The motor gear is the small gear on the top left.
The timing gear is the largest gear in the center.
Loading ...
Loading ...
Loading ...