Loading ...
Loading ...
Loading ...
(76,1)
北米Model "A2620BE-B" EDITED: 2022/ 6/ 24
system.
If it is hard to install the child restraint
system because the anchorage cover
returns to the original position, press the
anchorage cover to the seat cushion until it
is flat.
3. If the child restraint system makes
contact with the head restraint of the rear
seating position where the child restraint
system is to be installed, raise the head
restraint to the extended position. If the
child restraint system still makes contact,
remove the head restraint. For details,
refer to “Head Restraint Adjustment”
�P45.
CAUTION
Store the head restraint that has
been removed in the trunk (Legacy)
or the cargo area (Outback/Subaru
Outback Wilderness). Do not place
the head restraint in the passenger
compartment to prevent it from
being thrown around in the passen-
ger compartment in a sudden stop
or a sharp turn.
4. For Outback/Subaru Outback
Wilderness models, adjust the seatback
to the upright position.
5. While following the instructions sup-
plied by the child restraint system manu-
facturer, connect the lower hooks onto the
lower anchorages located at “
” marks on
the bottom of the rear seatback. When the
hooks are connected, make sure the
adjacent seatbelts are not caught.
6. If your child restraint system is a
flexible attachment type (which uses tether
belts), push the child restraint system into
the seat cushion and pull both left and right
lower tether belts up to secure the child
restraint system by taking up the slack in
the belt.
7. Latch the top tether hook onto the
tether anchorage that is located on the rear
shelf (Legacy)/behind the rear seat
(Outback/Subaru Outback Wilderness)
and tighten the top tether firmly. For
additional instructions, refer to “Top Tether
Anchorages” �P75.
Child Restraint Systems
74
Loading ...
Loading ...
Loading ...