Loading ...
Loading ...
Loading ...
Lt}
.o
13
Lt}
i
Lt}
O
Lt}
- V
f
I I!
iii_iii/iiiiii!li_i_i_!i
iiiiiltiiiiiiiii!iiiii_iiiiii
iiiiii_iiIilIilIim
i,...
0
E
0
Before you call for service...
Troubleshooting Tips
Excessivesmoking
Possible Causes
Excessivesoil.
What To Do
Touchthe Clear/Off pad. Open the windows to
rid the room of smoke. Wait until the LOCKEDDOOR
light goes off. Wipe up the excess soil and resetthe
clean cycle.
Oven door will not open
after a clean cycle
Oven too hot.
• Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
Ovennot clean after a Oven controlsnot properly set. • Seethe Using the self-cleaning upper oven section.
cleancycle Oven was heavily soiled. • Cleon up heavy spillovers before starting the cleon
cycle. Heavily soiled ovens may need to self-cleon
again or for o longer period of time.
"Door"appears in the Latch handlewas moved to the • Move the latch handle to the right only when setting
display[onmodels right but a program other than the self-cleaning cycle.
with a door latch} self-clean was selected.
"LOCKDOOR"flashes
in the display
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
wag to the right.
• Closethe oven door and on models with a latch, move
the latch all the way to the right.
LOCKEDDOORlight
is on when you wont
to cook
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
* Touchthe Clear/Off pad. Allow the oven to cool
and then, on models with a door latch, unlock the door.
"F--"and a number or On models with a door latch, • The latch may hove been moved, even if only slightly,
letterflash in the display if a function error code appears from the locked position. Hake sure the latch is moved
during the self-cleaningcycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Touchthe Clear/Off pad. Allow the oven to cool for
one hour. Putthe oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven racks are The nickel racks (ifso equipped) • Apply a small amount of vegetable oil to a paper
difficult to slide were cleaned in a self-cleancycle, towel and wipe the edges of the oven racks with
The gray porcelain-coated racks the paper towel. Do not spray with Pam®or other
(if so equipped)were improperly lubricant sprays.
cleaned.
"Probe" appears in This is reminding gou to enter a * Entera probe temperature.
the display [somemodels} probe temperature after plugging
in the probe.
LOCshows in the
display
The Gas/Control Lockout feature • Be sure the surface burner controls are turned OFF.
is activated. Turn this feature off to use the range. Seethe Gas/Control
Lockout section.
54
Loading ...
Loading ...
Loading ...