GE - General Electric JGB810SEP1SS GE gas range

User Manual - Page 50

For JGB810SEP1SS.

PDF File Manual, 60 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Installation Instructions
[] ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air adjustment shutter for the top (broil) burner is in
the center of the rear wall of the oven.
ustment
shutter
The shutter for the bottom (oven) burner is near the back
wall behind the warming drawer. Remove the drawer. See
the Core ond cleoning of the ronge section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil) burner should be steadg with
approximately 1" blue cones and should not extend out
over the edges of the burner baffle.
To determine if the bottom burner flames are burning
properly, remove the oven bottom. Flames should have
approximatelg 1" blue cones and, if range is supplied
with natural gas, should burn with no gellow tipping.
(With most LPgas, small yellow tips at the end of outer
cones are normal.) Flames should not lift off burner ports.
If lifting is observed, gradually reduce air shutter opening
until flames are stabilized.
I-8-1ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY (CONT.}
Oven
To remove the oven bottom:
A. Remove the screws holding down the rear of the oven
bottom.
B. Grasp the oven bottom at finger slots on each side.
C. Lift the rear of the oven bottom enough to clear the lip
of the range frame, push it back, and then pull it up
and out.
i91 LEVELING THE RANGE
A. Install the oven racks in the oven and position
the range where it will be installed.
lel , _ Lower Ra_sge :aOr_eer
range
range
(on some models) (on some models)
a.
Check for levelness bg placing a spirit level or a cup,
partiallg filled with water, on one of the oven racks,
If using a spirit level, take two readings-with the level
placed diagonallg first in one direction and then the
other,
C.
Remove the drawer. See the Core ond cleoning of the
ronge section. The front leveling legs can be adjusted
from the bottom and the rear legs can be adjusted
from the top or the bottom.
D. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level.
E.After the range is level, slide the range awag from the
wall so that the Anti-Tip device can be installed.
5O
Loading ...
Loading ...
Loading ...