Loading ...
Loading ...
Loading ...
EN
18
Installation
www.bora.com
1
2
Fig. 6.16 Securing the cooktop extractor
[1] Tensioning screw
[2] Clamp
Turn the four clamps [2] under the worktop.
Tighten the clamp screws [1] with max. 10 Nm.
Check that the cooktop extractor frame is positioned
correctly.
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
6.5.2 Preparing to install the substructure
module, silence module and plinth fan
INFO The floor unit must not be supported on the
plinth fan housing.
INFO For correct installation, the slide-in units of the
base cabinet must be shortened depending on
the installation situation.
INFO The plinth fan must only be installed
horizontally.
Now adapt the cooktop extractor system to the
worktop height by shortening the silence module at the
cut marks using a fine saw.
1
2
Fig. 6.14 Installing the cooktop extractor
[1] Cooktop cut-out
[2] Cooktop extractor frame
Insert the cooktop extractor frame [2] in the middle of
the relevant worktop cut-out.
Precisely position the cooktop extractor.
1
2
Fig. 6.15 Height adjustment plates
[1] Height adjustment plate
[2] Cooktop extractor frame
If applicable, insert the height adjustment plates [1].
Loading ...
Loading ...
Loading ...