Loading ...
Loading ...
Loading ...
ii.... ii,m,i ,,wlllw,,,i ,i....... i ii,,
................... Glossary .............................................
Anti-kickback Pawls: Pivoted objects with
teeth which help prevent workpiece kickback.
Arbor: The bar or shaft that holds the saw
blade.
Bevel: The slanting of the motor and blade to
an angle between 0° and 90 °.
Crosscut: Cutting a workpiece to length,
Dado' Non-through cut which produces a
square sided notch or trough in the workpiece.
Featherboard: Device used to keep
workpiece in contact with the fence during rip-
ping.
Freehand: Performing a cut without the use
of fence, guide or hold-down designed to
prevent the workpiece from moving during
the cutting operation.
Heel: Misalignment of the blade relative to
blade travel path.
Infeed: The end of the saw blade where the
workpiece is fed during ripping; identified by
the absence of pawls,
In-Rip: Positioning the the motor toward the
front of the table, the blade toward the fence°
Kerr: Slot caused by removal of material by
the blade in a through cut, or a shallow slot
produced by the blade in a non-through cut.
Kickback: Uncontrolled throwing of the
workpiece during ripping.
Miter: Positioning the saw arm to the right or
left of 0 °.
Molding Cut: Non-through cut which
produces a contoured surface on the
workpiece_
Outfeed: The end of the saw blade where the
rip cut workpiece leaves the saw blade; iden-
tiffed by presence of pawls.
Out-rip: Positioning the motor toward the
fence, the blade toward the front of the table
during ripping.
Parallel: When two surfaces are the same dis-
tance apart at all points.
Perpendicular: When two surfaces are 90 °
(square) to each other°
Push BloeiffAuxiliary Fence: Two accessories
used together for ripping a workpiece be-
tween 1/2 inch and 2 inches wide°
Push Stick: Cutting accessory used during rip-
ping a workpiece between 2 inches and 6 in-
ches wide.
Revolutions Per Minute (RPM): Number of
turns completed by an object in one minute.
Ripping: Used to change the width of a
workpiece by cutting along its length.
Spreader: Used during ripping to keep the
kerf from closing and pinching the blade. It
helps prevent kickback°
Workpiece: Object being cut by the saw.
68
Loading ...
Loading ...
Loading ...