Loading ...
Loading ...
Loading ...
Mounting the Front Table
1_ Make sure that thefi"ont table is upside
down.
2_ Place a tee nut over' the leveling hole and
hammer it into place_ (Figures 59 & 59A)
Tee Nut ---..,-_, ._,)
Fig..59
rNv
Fig, 59A - Nut Tee
3.. Slide a U-clip onto the center channel of
the saw as shown, (Figures 60 & 60A)
U-Clip
Fig. 60
Fig. 60A- U Clip
4. Place the fi'ont table on the saw so that the
mounting holes in the table line up with holes
in the table supports and center' channel of
saw. (Figure 61)
Bolt
Fig,, 61
5. Start the cup point set screw through the
leveling hole. Do not tighten. (Figures 61 &
62)
Fig_ 62 - Cup Point Set Screw
& Put a washer in each of the mounting
hotes_ (Figures 61 & 63)
Q
Fig,, 63 - Washer for Mounting Holes
7,. Start a pan head machine screw through
the center mounting hole Do not tighten.
(Figures 61 & 64)
Fig° 64 - Pan Head Machine Screw
26
Loading ...
Loading ...
Loading ...