Loading ...
Loading ...
Loading ...
Front Bolt
Table Support
Rear Bolt
Fig. 57
14. Mark the point on the table support un-
der the center of the arbor shaft° (Figure 58)
15_ Place the handle end of the arbor wrench
over this point. (Figure 58)
16. Slide the front end of the table support
up or down until the handle end of the arbor
wrench just fits between this point and the
arbor shaft. The wrench should slide back
and forth with slight contacL
17_ Tighten the bolt under this point using a
1/2 inch wrench,
If the arbor wrench will not fit between the
arbor shaft and the table support at any point,
repeat steps 8-21 until the table supports are
level, or
If there is a gap between the arbor wrench
and the arbor shaft at any point, repeat steps
8-2t until the table supports are level.
Rear Bolt
t I
r Wrench
Front Bolt
Table Support
Fig_ 58
184 Repeat steps 13-17 with the arbor shaft
over the front and rear bolts on the right table
support. Slide the rear end of the table sup-
port up or down when the arbor shaft is over
the rear bolt (see step 16).
19. Move the arbor shaft over all four points
again.
20. Place the handle end of the arbor wrench
over each point and make sure that the arbor
shaft just touches the wrench. The wrench
should slide back and forth with slight con-
tact.
21. If the arbor shaft just touches the arbor
wrench at each point, go to the next section,
or
25
Loading ...
Loading ...
Loading ...