Loading ...
Loading ...
Loading ...
5. Cut out a notch from the 12 inch side of
the 3/8 plywood that is 9 1/2 inches long by
3/8 inch wide. The dimensions of the remain-
ing 3/8 plywood are shown in Fig. 165.
6. Glue the 3/4 inch plywood on top of the
3/8 inch plywood so that their t2 inch sides
are square, as shown;
These Edges Must
Be Parallel
5-1/8
3/4" Plywood
t -01/4x
1-1/4
3/8" Plywood
2-1/2
3/8 3/8
Note: All Dimensions in Inches
Fig 131 Push Block Dimensions
7. Cut a piece of plywood 3/8 inch wide by
2 1/2 inches long and glue it to the underside
of the 3/8 inch plywood in line with the edge
that sticks out. Do not use nails because if
you accidently cut into the push block with
the saw blade, the nails will dull the blade.
8. Lay the push block on top of the auxiliary
fence to make sure that their widths match ex-
actly, and are each 4 3/4 inches.
Fig. 132 Way to Use Auxiliary Fence/Push Block
65
Auxiliary Fence for Edging
Make an auxiliary fence for edging:
o before doing edging with the arm at
0° miter position.
o when existing ones have been
damaged.
To make a fence for edging:
I. Use 3/4 inch solid (knot-free) lumber.
2. Cut to the dimensions shown.
Auxiliary Fence Spacer Table
Rear Table
e
Front Table
- 17 ----4 I-,---- 16 ---_1
I' ' 45"_-_-/z_45° " ' 1-22_1/43/4
-1 --L
Note:AI,DimensionsinInches 3/4-4
Fig. t33 Auxiliary Fence for Edging
For use of the molding head or drum sander
with saw arbor vertical, the rear table re-
quires an opening (next to rear face of fence)
for arbor clearance. Cut opening directly
below arbor in vertical position. Opening
dimensions are shown below.
_ _,--3 3-1/2
-4 T
Note: All Dimensions in Inches
Fig 134 Rear Table Opening Dimensions
Loading ...
Loading ...
Loading ...