Loading ...
Loading ...
Loading ...
6. Unlock the miter lock.
7. Move the arm to the right until it snaps
into the 45 ° position.
8. Lock the miter lock.
9. The display should say:
J
MIT _ _=- p
.J.u
10. Unlock the miter lock.
11. Move the a_rn to the left until it snaps
into the -45°position.
12. Lock the miter lock.
13. The display should say:
1 L -ni
MiT L _
" g.U
14. If the display is correct at a!l three points,
go to the next section, or
If the display is not correct at one or more of
these points, go to step 15.
15. Unscrew the two mounting screws on the
back of the arm and take off the rear ann
cover.
16. Untock the miter lock.
17. Move the ami to the right until it snaps
into the 45 ° miter position.
18. Lock the miter lock.
19. Loosen the mounting screws on the miter
encoder until the encoder will slide to the
right and left. (Figure 96)
Fig_ 96 - Screws for Miter Encoder
20. Slide the encoder slightly until the digital
display says:
[
MIT
You may need to tap on the encoder to move
it, but do not force it or hit it hard.
21. Tighten the mounting screws on the en-
coder.
22. Repeat steps 2-13 to make sure you did
not move the encoder when tightening the
mounting screws.
23. If the display is still not correct repeat
steps 16 _ 22 until the miter encoder is in the
right position, or
If the display is correct, put the rear ann
cover back on the radial arm, Go to the next
section.
41
Loading ...
Loading ...
Loading ...