Loading ...
Loading ...
Loading ...
go to the next section, or
If the display says:
I
push the REF SET button again, Then go to
the next section°
Out-rip Reference
The "0" reference point for out-rip is usually
set with the blade ten inches from the fence°
1. Unlock the swivel lock,
2, Turn the motor to the out-rip position with
the motor' between the blade and the fence.
3. Lock the swivel lock.
4. Unlock the table locks and move the fence
behind the spacer and rear table (Figure 1!1)
5. I_x3ck the table locks.
8. Lock the rip lock.
9. Push the RIP button.
10. If the display shows the O-RIP flanction,
go to step 11, or
If the display shows the RIP function, push
the RIP button again. Then go to step 11.
11. Push the REF SET button.
I2. If the display says:
°°1
o..tP °U U
!3 Push the REF StiTbutton again_
lhe display will say:
O-RIP
i
t Fe Ft 1
LU.U U
6. Unlock the rip lock.
7. Move the motor until the blade is 10 inches
in front of the fence. Use a framing square,
ruler or tape measure to measure this dis-
tance. (Figure 98)
Blade
Fence
Fig., 98 - Out-Rip Reference
44
Loading ...
Loading ...
Loading ...