Loading ...
Loading ...
Loading ...
6. Put the casters (wheels) on the shelf and
shelfstiffenero Since the shelf is upside down,
the wheels will point up o Line up four holes
on each side. (Figme 16)
% Put truss head bolts through the holes on
each side. Put a lockwasher and hex nut on
each bolt and tighten using a 7/16 inch
wrench or socket°
8. Find the right and left side panels, Look
carefully to find the "R" and "L" stamped
in the metal near the center of the wide edge.
These stamps are the easiest way to tell the
right side panel from the left. (Figure 1'7)
R
Fi9.17
9. Turn the right side panel so that the J-
shaped slot is at the bottom and facing you.
10. Put a spacer inside the right side panel as
shown_ The side of the spacer with two round
holes should be opposite the J-shaped slot in
the side panel, and the side with one larger
hole should be on the bottom. (Figure 18)
Spacer
One Larger Hole
Fig. la
Right Side Panel
, -Shaped Slot
/
Plastic Cover
12
1 t_ Put two truss head bolts through right
side panel and spacer, one on each side.
12. Put a lockwasher and hex nut on each
bolt and tighten using a 7/16 inch wrench or
socket.
13. Put a plastic cover over the J-shaped slot
in the side panel. (Figure )
t4. Repeat steps 9-13 with the left side
panel.
15. Attach two hinges to the right side panel
above the spacer, using four truss head bolts,
lockwashers, and hex nuts. Tighten with a
7/16 inch wrench_ (Figure 19)
%
Spacer
Fig. 19
!6. Lay the shelf on the rear edge with the
bottom side toward you_ The angled end of
the lower support should point up.
17. Place the right side panel on the right
side of the shelf. The spacer should be on the
inside of the cabinet. (Figure 20)
Loading ...
Loading ...
Loading ...