Loading ...
Loading ...
Loading ...
ASSEMBLY
Before mounting the saw on legs, a stand or a bench, the
Table Insert and Blade Squareness must be checked at this
time.
INSTALLING HANDWHEE LS
1. Line up FLAT SPOTS on shaft and handwheel, push
handwheel onto shaft. Install screw and Iockwasher to
lock handwheel on shaft.
LOC:KWASHER
/
10-32 X 3/4 IN.
ELEVATION PAN HEAD SCP_W
/
HANDWHEEL TILT rtANDWHEEL
CHECKING TABLE INSERT
2. Insert should be flush with table top. Check as shown.
Loosen flat head screw tha_ holds insert and adjust the
four set screws as necessary. Tighten flat head screw•
Do not tighten screw to the point where it deflects the
insert.
3/32 IN
SETSCREWWRENCH
3. To remove insert•
A) Loosen Screw
B) Lift insert from front end. and pull toward front of
saw,
To replace insert.
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten screw.
Do not tighten screw to the point where it will deflect
the insert.
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT: I_LADE must be _QUARE (90 O) to TABLE,
in order to proceed with assembly.
To check for blade squareness, refer to "BLADE TILT, OR
SQUARENESS OF BLADE TO TABLE" adjustment on
page 32.
CHECKING BLADE FOR HEEL
IMPORTANT: Saw blade MUST be parallel to miter gauge
groove.
To check for parallelism, refer to "HEELING
ADJUSTMENT OR PARALLELISM OF SAVBLADE TO
MITER GAUGE GROOVE" adjustment on page 31 and 32.
Loading ...
Loading ...
Loading ...