Loading ...
Loading ...
Loading ...
45 ° POSITI ON
TILT blade to LEFT as far as it will go. It will stop when
the PIVOT NUT is against the 45 ° STOP COLLAR.
A. Place an ACCURATE square against blade. Make
sure square is not touching the TIP of one of the
saw TEETH.
If blade is 45 ° to table:
A. Check pointer.
If POINTER DOES NOT !_oint to the 45 ° mark on the
scale;
A. Remove Elevation Handwheel.
B. Loosen two screws on scale and adjust scale until
POINTER points to 45 ° mark.
C. Install Elevation Handwheel.
If blade is NOT 45 ° to table ..
and SCALE must be ADJUSTED.
1.
2.
the 45 ° STOP COLLAR
Remove Elevation Handwheel.
Using a small size screwdriver, reach thru curved
slot in front trim panel and loosen BOTH setscrews
in 45 ° STOP COLLAR.
NOTE: If you can't reach the setscrews, turn the
TILT HANDWHEEL slightly.
3. ROTATE the STOP COLLAR moving it IN or OUT
and TILT blade RIGHT or LEFT... checking with
your square until blade is 45 ° to table.
4. TIGHTEN the setscrews.
NOTE: If you can't reach the setscrews, turn TILT
HANDWHEEL slightly.
5. Loosen two screws on scale and adjust scale until
POINTER points to 45 ° mark.
6. Install Elevation Handwheel.
TI LT MECHANISM
The handwheel should turn freely without binding. The
turning action can be adjusted by tightening or loosening
the screws in the bearing retainer.
NOTE: Tilt Nandwh_l mu_t b_ r_n_oved to adjust. When
adjusting the screws in the bearing retainer, hold the nut
nside using a 3/8 in. wrench
/
TILT HANDWHEEL
ADJUST THESE
. TWO SCREWS
/
I L/j
l'/
34
Loading ...
Loading ...
Loading ...