Loading ...
Loading ...
Loading ...
If tooth does not touch the same amount ... the
mechanism underneath must be adjusted to make the
blade PARALLEL to GROOVE.
A. Rear trunnion must be moved TOWARD the
combination square if there is a space between
marked tooth and end of square in step 4.
B. Rear trunnion must be moved AWAY from the
square if marked tooth pushes square out of
position in the groove.
FRONT TRUNNION
REAR TRUNNION
7. Loosen all three screws that hold the rear trunnion and
all three screws that hold the front trunnion.
NOTE: All six screws can be reached through back of saw.
Use a 9/16-in. wrench. To reach left-hand front trunnion
screw, tilt blade to 45 °. After loosening screws reposition
blade at g0 °.
REAR-TRUNNION
SCREWS
LEFT-HAND
RIGHT-HAND CENTER (BEHIND HERE}
(BEHIND HERE)
/ i ",,
FRONT-'rRUNNIO N SCREWS
EDGEoFTRUNNIOn
CLAW HAMMER
8.
Using a wood block and mallet as shown, move rear
trunnion to right or left as reauired to realign the blade.
f necessary, shift front trunnion in similar manner but
do NOT move front trunnion unless necessary. Recheck
the alignment with the square, then securely retighten
all six trunnion screws.
PLACE BLOCK HERE
BLOCK
-- OR HERE
;tEAR OF SAW
EDGE OF
CRADLE
BLADE TILT, OR SQUARENESS
OF BLADE TO TABLE
90 ° (SQUARE) and 45 ° (BEVEL) STOP COLLARS.
When the bevel pointer is pointing directly to the "'O" mark
on the bevel scale, the sawblade should make a SQUARE
cut 90 ° to the table.
To check for SQUARENESS:
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET.
1. Raise blade all the way UP... raise blade guard.
2. Place the souare against blade. Make sure square is not
touching the TIP of one of the saw TEETH.
32
Loading ...
Loading ...
Loading ...