Loading ...
Loading ...
Loading ...
Insertboltsthroughholesin middle and on right side of
front of saw table ... install Iockwashers and nuts.
DON'T SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
6.
7.
Remove the 3 screws from rear of table extension.
Insert 1 in. long screws in SECOND and FOURTH holes
of rear bar and attach to table the same way.
Insert ends of FENCE GUIDE BAR ROD through
round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded ... the
SELF THREADING NUTS will cut threads on the rod
as they are screwed on.
9. Hold rod with one hand and with a 1/2 in. wrench or
pliers start screwing on ONE of the nuts only A TURN
OR TWO... screw on other nut the same way.
10. Using TWO 1/2 in. wrenches or pliers tighten both of
the nuts.
11, Slide the bars so that screws are in the MIDDLE of the
slotted holes.
12. Position rip fence over miter gauge groove, holding up
the rear end while engaging front end with bar ...
lower fence onto table.
11
Loading ...
Loading ...
Loading ...